#575 Alloy

Thank you for using UNITED'S alloys.

UNITED'S 575 ALLOY may be used for 10K - 18K casting, and hand-made (rolling), which produces a green finished color.

You should obtain excellent results by following a few simple instructions.

MELTING

We do recommend pre-graining all alloy and fine gold before casting to assure a uniform mixture.

FLASK TEMPERATURE
Normal recommended temperature.

FLUXING
Boric Acid is the recommended flux. Use as little flux as possible. Do not use carbon fluxes or any fluxes designed for refining; i.e., soda ash, saltpeter, etc. Avoid flux in bottom pour automatic casting units.

QUENCH TIME
8 - 12 minutes. Casting for hand-made, quench ingot immediately.

INVESTMENT REMOVAL
Most standard investment removers will successfully remove the investment powder. Fluoric-based investment removers are the best for removing the silicon oxide invisible coating. UNITED'S Brite-Cast Investment Remover also works very well.

REMELTING
We recommend 50% rejuvenation for remelting.

NOTES
Melt temperature may vary with type of unit. This alloy is designed for casting and hand-made (rolling).

TECHNICAL ASSISTANCE
Always available…
Call 1-800-999-3463 / 1-800-999-FINE
E-mail / doc@unitedpmr.com
Web-Site / www.unitedpmr.com